How to make Bimini Twist loop?
This line system is for super sensitivity and strength for trout, bass, dolphin fish and any with PE braid (spectra) line of up to 50 lb lines. If you want a system with Nylon line, go other.
| 1) Take about a foot of main PE line for the double-line loop. Rotate end of loop about 30 times. The smaller the loop, less you have line trouble. Try with large loop first, and them make it smaller later. |
 |
| 2) Hold the end of line at your
mouth, and put 2 -3 fingers in to the loop. Force the twist tight. 3) Slowly open the fingers and gradually loosen the tension of line at your mouth. Then the line at mouth will roll over the column of twist. |
 |
| 4) The line at your mouth should
come rough at first and then tightly on the twist. This rough section spread the
force efficiently from the main line to the loop. 5) When the line at mouth come to the end of the twist, tie the end with half hitch on a line of loop two times. This end will not receive any force and just tie it. Cut the excess end and that's it!! |
 |
Now you have a reliable loop, which is almost twice strong as main line.
Next is to tie the nylon or fluorocarbon leader to the loop using SIG knot.
SIG Knot is here.